TMSS GERMANY Telemechanique Sensors ribinis jungiklis Unterteil m.Kopf 2ÖS ZCKS404

Die-cast zinc alloy housing, plunger head right in the body, and IP68 sealing — the TMSS GERMANY ZCKS404 limit switch is built to take a beating where dust, water and vibration are part of the daily routine.

Kodėl verta rinktis

This switch belongs to the OsiSense XCKS series and is made for real industrial conditions. The Zamak (die-cast zinc alloy) body resists impacts and corrosion, while the integrated plunger head gives you direct, repeatable actuation without extra levers or arms to align.

Kam tinka

It suits automation engineers, machine builders and maintenance technicians who need dependable position sensing and control circuit switching on conveyors, packaging lines, doors, gates or any moving machine part. If your equipment runs in a washdown area or outdoors, the IP66/IP67/IP68 rating means you can mount it without worrying about dust or water ingress.

Pagrindinės savybės

• 2 normally open (NO) contacts for control circuit switching
• Plunger head integrated into the body for direct actuation
• Die-cast zinc alloy (Zamak) housing for mechanical strength
• IP66, IP67, IP68 protection against dust and water ingress
• Wide operating temperature range from -25 to 70 °C
• High mechanical durability of 10 million cycles

Specifikacijos

• Product type: Limit switch
• Series: OsiSense XCKS
• Contact configuration: 2 NO
• Cable entry: 1 x M20 x 1.5
• Housing material: Zamak (die-cast zinc alloy)
• Head type: Plunger head (integrated)
• IP rating: IP66, IP67, IP68
• Operating temperature: -25 to 70 °C
• Rated insulation voltage (Ui): 500 V (degree 3 pollution)
• Rated impulse withstand voltage (Uimp): 6 kV
• Rated operational current: 3 A (AC-15, 240V); 0,27 A (DC-13, 250V)
• Mechanical durability: 10,000,000 cycles
• Electrical durability: 5,000,000 cycles (AC-15, 240V)
• Mounting type: Body fixing (2 screws)
• Number of poles: 2
• Terminal type: Screw clamp terminals
• Switching operation: Snap action
• Electrical circuit type: Control circuit

Kaip naudoti

Mount the body with two screws, feed the cable through the M20 x 1.5 entry, and tighten the screw clamp terminals. The snap-action mechanism ensures a clean, fast contact changeover, which helps protect the contacts from arcing and extends service life.

Patarimai: before final tightening, check that the plunger lines up squarely with the actuating cam or stop — misalignment is the most common cause of premature wear. Always use a cable gland rated for M20 x 1.5 to keep the IP66/IP67/IP68 seal intact. In outdoor or washdown installations, add a drip loop in the cable and re-check terminal torque after the first week of operation.